DIY Fabric Linen Table Runner

Have a nice dining tabular array y'all want to show off but not quite committed to a total tabular array cloth? Create your ain custom table runner with only 1 k of textile! Simply a little cut, sewing, and fringing and you're on your way to a cute slice that will accent your table for all your holiday hosting needs!

DIY Neutral Linen Table Runner - MAterials

Supplies:

Sewing Motorcar
Thread
Iron
Ironing lath
Scissors
Tape measure
Cutting board
One thou of linen fabric
Pins

Instructions:

DIY Neutral Linen Table Runner Instruction

1.Depending on the width of your table and your fabric, y'all should hands be able to create a runner out of ane yard of fabric. If you accept a longer table (that seats 8 or and so), you can cut your fabric (here nosotros used a material that was 55″ wide) into thirds. If your tabular array is shorter, you tin can cut your fabric in one-half (just keep in mind the runner will be wider so take the time to plan it out and predetermine your decisions). Cut your fabric as directly equally possible which will make the post-obit steps easier (you can also take your local fabric store pre-cut these strips for you if possible).

two.Once you lot have your strips of fabric, fe out all the wrinkles using your atomic number 26 and ironing board. Depending on the atomic number 26 you use, you lot may demand to use a cover cloth over your linen textile to proceed from damaging it with your fe. You tin besides use a depression heat setting on your fe or steam out some of the wrinkles (just allow time to dry before you move to the next pace).

3.Once your fabric strips are ironed out, place ii strips of fabric together, right sides together, wrong sides out. Pin at the top and sew across the short edge. This will create one long skinny strip of material. Remove your pins and fe your seam one direction or the other so information technology doesn't stick upward when yous lay the runner flat on a surface. Echo this stride with the last strip of cloth if you lot cease up cutting your fabric into three strips for your runner.

four.Once the runner is sewn together, fringe the sides of the material. Practice this by by pulling out the closest thread on the side of the runner that runs parallel to the long sides of the runner. Continue pulling out threads from the side until you create a nice fringe. Continue this on the other side of the runner. This will create a nice neutral fringe and permit you to avoid hemming the edges.

Place your runner down the middle of your table, set your place settings, serve your meal and enjoy your beautiful table and visitor!